Hand dispensing valve ID2.5
Available downloads for "Hand dispensing valve ID2.5"
Login
Product information "Hand dispensing valve ID2.5"
Based on the time-pressure dispensing principle, the needle dispensing valves are most effective in continuous applications of low to high viscosity media. Consisting of two structurally separate parts, they have the advantage that material cannot leak into the drive cylinder and interfere with the valve needle movement. The size of the orifice is regulated simply by a stop screw. A special, adjustable seal closes the valve needle off from the valve head, ensuring a perfectly clean and precise application of every single shot. The material passageway can be flushed as and when necessary.
| Drive cylinder version: | Initiator holder |
|---|---|
| Inner diameter: | 2.5 mm |
| Material inlet connection: | G 1/4" |
| Material inlet version: | Inner thread |
| Material outlet connection: | M12x1 |
| Material outlet version: | with cannula conn. |
| Maximum pressure: | 315 bar |
| Mech. resistance: | Increased resistance |
| Operating type: | Pneumatically |
| Seal type: | Lip seal |
| Version: | Handle vertical |
| Working pressure: | 250 bar |
Accessory Items
MICRO-FLOW Sensor cpl.
Article number: 403.04.20
The micro-flow sensor detects whether material has been dispensed or not, without contact with the material. An analogue signal is amplified and forwarded to the electronic controller. The sensor is able to capture up to 120 metering cycles per minute. Should the electronic controller fail to send a signal as a result of no material flow, the master control unit will activate an alarm.
Price on request
Electronic signal transmitter with plug M8x1 and cable 5m
Article number: 1025106
The stroke detection device monitors the correct activity of various valve types. Detecting the upstroke movement of the dispensing needle or the metering piston, it sends signals to indicate the proper functioning of a valve.
Price on request
